기본 정보
인증
RoHS 준수, CB, CCC, ISO9001, CE
Type
Temperature Controller
Control Method
Electronic Type
Operating Principle
Compression Refrigeration Equipment
Cooling Purpose
Cold Storage
Analog Inputs
1xptc or Ntc
Digital Outputs
1xspdt 8(4)a 250VAC
Display
LED 3 Digits + Sign
Measurement Range
-50…+140°c
Accuracy
Better Than 0,5% of Full Scale + 1 Digit
제품 설명
SF-102S Digital Temperature Controller For Freezer,Chiller, Refrigeration System, Condensing Unit
GENERAL DESCRIPTION -DIGITAL CONTROLLER XR02CXModel XR02CX, format 32 x 74 x 50 mm, is a digital thermostat with off cycle defrost designed forrefrigeration applications at normal temperature.
It provides a relay output to drive the compressor.
It is also provided with 2 NTC probe input.
The instrument is fully configurable through special parameters that can be easily programmed through the keyboard or the by HOTKEY.
It has 4 relay outputs to control compressor, fan, defrost, which can be either electrical or reverse cycle (hot gas) and light (configurable).
It could be provided with a Real Time Clock which allows programming of up to 6 daily defrost cycles, divided into holidays and workdays. A "Day
and Night" function with two different set points is fitted for energy saving.
It is also provided with up to four NTC or PT1000 probe inputs, the first one for temperature control, the second one, to be located onto the evaporator, to control the defrost termination temperature and to managed the fan. One of the 2 digital inputs can operate as third temperature probe. The fourth probe is used to signal the condenser temperature alarm or to display a temperature.
The RS485 serial output allows to connect the unit to a network line ModBUS-RTU compatible such
as the Dixell monitoring units of X-WEB family. The HOT key receptacle allows to program the controller by means the HOT KEY programming keyboard.
The instrument is fully configurable through special parameters that can be easily programmed
through the keyboard.
Features :
It is an intelligent controller
and applicable to the compressor of one HP.
Temperature Display / Temperature Control
Automatic defrost by electric heater or hot gas/Light Control
Electric heater defog
High,Low temperature alarm
Self Testing /Parameter Locking
Specifications :
Range of temperature display:-45~150ºC
Range of set temperature:-45~50ºC
Accuracy:±1ºC
Temperature sensor: NTC, two sensors,2m(L)
Compressor: N.O. 30A/250VAC (applicable to one HP Compressor, if more it needs to connect an AC contactor)
Defrost: N.O. 10A/250VAC
Evap. Fan: N.O. 5A/250VAC
Light: N.O. 5A/250VAC
Defog: N.O. 10A/250VAC
Dimensions:142(Length)×40(Width)×40(Depth)mm
Mounting hole dimensions:138(Length)×32.5(Width)mm
Technical Parameters :
Paramete | Function | Set range | Default |
E1 | Lower setpoint limit | -45ºC~Set temp. | -30ºC |
E2 | Higher setpoint limit | Set temp.~50ºC | 30ºC |
E3 | Temp.hysteresis | 1~10ºC | 4ºC |
E4 | Comp.start delay time | 0~10Min | 2Min |
E5 | Offset on room temp. | -10~10ºC | 0 |
E6 | Offset on evap.temp. | -10~10ºC | 0 |
F0 | Defrost function | 0=Electric heater 1=Hot gas | 0 |
F1 | Max.Defrost duration | 1~60Min | 20Min |
F2 | Defrost interval time | 0~24Hr | 6Hr |
F3 | Defrost termination temp. | 0~50~0ºC | 8ºC |
F4 | Display during defrost |
Notes for Installation
1. Sensor leads must be kept separately from main voltage wires in order to avoid high frequency noise induced. Separate the power supply of the loads from the power supply of the controller.
2. When installation the sensor shall be placed with the head upward and the wire downward; The evaporator sensor must be installed between the fins of the evaporator in the area, where probably the ice is the thickest.
3.In case of long-distance sensor installation from the controller, the sensor cable may be prolonged up to 100 m max. without any re-calibration.
4.The temperature controller can not be installed in the area with water drops.
Accessories for the temperature controller
1. One attached transformer and two relays
2. Two temperature sensors
3. One installation stand
주소:
6f, Building No.2 Huamei Ind.Est., Jingnan Road, Buji Town, Longgang District, Shenzhen, Guangdong, China
사업 유형:
제조사/공장
사업 범위:
건축과 장식재료, 공업 설비와 부품, 교통 운송, 야금광산물과 에너지, 의약 위생, 전기전자, 제조 가공 기계, 철물, 측정 기계, 화학공업
경영시스템 인증:
ISO 9001
회사소개:
CNAU는 냉동 콤푸레셔, 냉동 및 에어컨 구성품 거래를 전문으로 하는 공유 시스템 회사입니다. 우리는 훌륭한 서비스 작업 팀과 풍부한 기술을 가지고 있습니다.
현재 L′Unite HERMETIQUE 압축기, COPELAND 압축기, BITZER 압축기, DANFOSS 제어장치 및 밸브, 롤러 에어쿨러, 캐스터 밸브 등 10개 이상의 브랜드 냉동 제품을 대표하고 판매하는 다양한 제품이 있으며 중국 남부에 있는 롤러의 일반 대리점입니다.
한편, 우리는 자체 브랜드 CNAU를 연구하고 개발했습니다. 이제 릴리프 안전 밸브, 수분 표시기, 냉동 오일 분리기, 흡입 라인 축압기, 액체 라인 필터 드라이어, 팬 및 모터, 응축기 및 공기 냉각기를 자체 브랜드 CNAU로 생산합니다. 당사의 제품은 ISO9001-2000 승인을 통과했으며, 수출 품질 인증을 받았습니다. 호주, 미국, 동유럽, 동남 아시아, 홍콩 등 많은 지역과 국가로 수출해 왔습니다.
CNAU는 뛰어난 강점과 풍부한 경험, 국내외 완벽한 명성을 바탕으로 입소문을 받았습니다. 완벽한 애프터 서비스를 통해 고품질 제품을 제공할 것을 약속합니다.
원스톱 냉동 시스템 솔루션을 생산하며, 맞춤 설정을 허용합니다. 문의 사항이 있으시면 언제든지 문의해 주십시오.
우리는 우리의 일등급 제품과 순진한 서비스로 당신에게 스플렌드한 미래를 창조하기를 희망합니다.